Change Password - Barco ULTRA REALITY 7000 R9002810 Owner's Manual

12. Installation menu
What can be done ?
To allow the network card to function properly, the network card has ta be configured.
If the LAN uses a DHCP server the different parameters will be filled in automatically. However if the LAN does not use a DHCP
server the parameters have to be filled in manually.
It is advised to consult the local IT administrator for support on configuring the Network.
How to configure the network when using a DHCP server?
1. Check the ON box (image 12-12)
2. Press Apply
The Apply button changes into in progress... while the network card tries to connect to the server.
Network configuration
DHCP
IP address
Subnet mask
Default gateway
HW address
Image 12-12
How to configure the network without DHCP ?
1. Fill in the IP address
2. Fill in the subnet mask
3. Fill in the default gateway
The HW (hardware) address of the card can not be changed.

12.8 Change password

How to change the password ?
1. Press MENU to activate the Toolbar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Change password (image 12-13)
5. Press ENTER
A dialogbox is displayed.
(image 12-14)
6. Use ← or → , the numeric keys on the remote , or the keypad to enter and confirm the new password.
Each character is displayed as an asterisk.
84
ON
OFF
Apply
R5976455 BARCO ULTRA REALITY 7000 30062003