Beats Part Group; Master Riff - E-Mu Xtreme Lead-1 Manual

Beats Part Group

_ _ _ _
All Parts assigned to a
Group will stop playing when
the Group key is triggered, then
untriggered even if the
individual Parts in the Group are
latched.

Master Riff

This screen is where you assign Parts to one of the four Groups. By
grouping, you can play multiple parts with a single key. A part can be in
one and only one group, or in no groups.
Select Part
P1
BEATS PART GROUP
Group:
To Assign a Part to a Group
Press the left cursor button to move the cursor under the Part field.
1.
Select the Part number using the Data Entry Control. Parts 1-16 can be
2.
selected. (All parts, shown as an "A", can be edited at once if "Edit All
Layers" is enabled in the Master menu.)
Move the cursor to the bottom line using the cursor keys and select the
3.
Group (1-4 or none) using the Data Entry Control.
Repeat steps 1 through 3 for all the Parts you wish to assign.
4.
Press the Enter/Home button or use the cursor keys to move the cursor
5.
back to the screen heading.
The Master Riff is selected from this screen. The Master Riff is used when
Master (M) is selected for BEATS in Beats mode enable screen.
MASTER RIFF
Plays: TranzAmbient 1
To Assign the Master Riff
Use the cursor buttons to move the cursor to the lower line of the
1.
display.
Select the desired Riff using the Data Entry Control. (BEATS Riffs are
2.
identified by the BTS prefix.)
If there is more than one ROM in XL-1 you can select Riffs from either
3.
ROM set. Move the cursor under the ROM ID and select using the Data
Entry Control.
Press the Enter/Home button or use the cursor keys to move the cursor
4.
back to the screen heading.
2
Xtreme Lead-1 Operation Manual 53
Arpeggiator/Beats Menu
SuperBEATS
XLEAD