Brother MFC-640CW User Manual page 95

Remote commands
95 Change the Fax
Forwarding, Paging or Fax
Storage settings
1 OFF
2 Fax Forwarding
3 Paging
4 Fax Forwarding number
6 Fax Storage
96 Retrieve a fax
2 Retrieve all faxes
3 Erase faxes from the
memory
97 Check the receiving status You can check whether your machine has
1 Fax
2 Voice
98 Change the Receive Mode
1 Msg Ctr
2 Fax/Tel
3 Fax Only
90 Exit
Operation details
You can select Off after you have retrieved
or erased all your messages.
If you hear one long beep, the change has
been accepted. If you hear three short beeps,
you cannot change it because something has
not been set up (for example, perhaps a Fax
Forwarding or paging number had not been
registered). You can register your Fax
Forwarding number by entering 4. (See
Changing your Fax Forwarding number on
page 6-10.) Once you have registered the
number, Fax Forwarding will work.
You can select Off after you have retrieved
or erased all your messages.
Enter the number of a remote fax machine to
receive stored fax message(s). (See page
6-10.)
If you hear one long beep, fax messages
have been erased from the memory.
received any fax or voice messages. If yes,
you will hear one long beep. If no, you will
hear three short beeps.
If you hear one long beep, your change has
been accepted.
Pressing 90 will allow you to exit Remote
Retrieval. Wait for the long beep, then replace
the handset.
REMOTE FAX OPTIONS (BLACK & WHITE ONLY) 6 - 9