Adobe 65036570 - Director - PC User Manual page 370

Property
whichModel.
inker.creases
model.inker.
creaseAngle
whichModel.
inker.boundary
Subdivision surfaces modifier properties
The subdivision surfaces (SDS) modifier causes the model to be rendered with additional geometric detail in the area
of the model that the camera is currently looking at. The additional detail must be created in a third-party modeling
application (usually by having the 3D application render the extra polygons during export of the model) and
imported into Director along with the 3D cast member. The SDS modifier is available only for models created
outside of Director. The SDS modifier should not be combined with the level of detail or toon modifier on the same
model.
Use the following properties to work with the SDS modifier:
Property
whichModel.sds.enable
d
whichModel.sds.
subdivision
whichModel.sds.depth
whichModel.sds.tensio
n
whichModel.sds.error
Collision modifier properties
The collision modifier allows a model to be notified of and respond to collisions. You can access a model's collision
modifier properties by using syntax such as
Detecting collisions and responding to collisions are separate tasks. If the
script has been registered to be notified of collisions by using the
instance receives a callback. However, the collision isn't resolved unless the
Access Description
Get and set or
TRUE (1)
whether lines are drawn when mesh boundaries
meet at a crease.
Get and set A floating-point value controlling crease angle
detection.
Get and set or
TRUE (1)
whether lines are drawn at boundary of surface.
Access Description
Get and set Enables/disables subdivision surfaces modifier
functionality.
Get and set The following are the possible values:
: mesh is uniformly scaled up in detail,
#uniform
with each face subdivided the same number of
times.
: additional detail is added only
#adaptive
when there are major orientation changes and
only to those areas of the mesh that are currently
visible.
Get and set Maximum recursion depth, with a range of 0 to
5, to which the subdivision surfaces modifier is
applied. At a value of
Get and set Percentage of matching between modified and
original surfaces.
Get and set Percentage of error tolerance. This property
applies only if sds.subdivision equals
.
#adaptive
model.collision.
value indicating
FALSE (0)
value indicating
FALSE (0)
, no change occurs.
0
.
whichProperty
enabled
setCollisionCallback()
resolve
ADOBE DIRECTOR 11.0
Default
TRUE (1)
0.01
TRUE (1)
Default
TRUE (1)
#uniform
1
65
0.0
property is set to , and a
TRUE
method, that script
property is also set to
TRUE
359
User Guide
.