Cancelling Communication - Kyocera ECOSYS FS-1135MFP Operation Manual

Cancelling Communication

The method for cancelling communication with this machine differs depending on the transmission method (memory
transmission or direct transmission) and communication form. Methods of cancelling in various cases are explained
here.
Cancelling Memory Transmission (while originals are being scanned)
Cancelling Memory Transmission (during communication)
During memory transmission, to cancel communication after it has started following the completed scanning of
originals, use the following procedure.
NOTE:
If user management is set to On, the administrator or the user who performs the memory transmission can
be canceled the job.
You can cancel transmission by disconnecting the telephone line. For details, refer to Cancelling Transmission
(Disconnection of Communication) on page 3-12.
Send Job Status:
0010
0011
0017 *********************
[ Cancel ]
a b
0123456789 r
p Broadcast
9876543210
[ Menu ]
During memory transmission, to cancel scanning of originals,
press the Stop key on the operation panel.
Scanning of originals is canceled, and the originals are
ejected. When originals remain in the document processor,
take them out from the original output table.
1
Press the Status/Job Cancel key.
2
Press the  or  key to select [Send Job Status].
3
Press the OK key.
4
Press the  or  key to select the job you want to
cancel.
5
Press [Cancel] (the Left Select key).
6
Press [Yes] (the Left Select key). Communication is
canceled.
NOTE:
Canceling is also possible by pressing [Menu] (the
Right Select key), then selecting [Cancel Job] and pressing
the OK key.
3-11
FAX Operation (Basic)
3