Electric Connection - Baumatic BT2385SS Instruction Manual

Electric connection

Electric connection may be carried
out by qualified service personnel
only!
Wrong connection may permanently
damage parts of the appliance and
render your warranty void!
Mains voltage of the user (230 V) must be
verified with the measuring device!
Three separating switches should be placed
in accordance with the mains connection.
• Before attempting the connection, check
whether the voltage indicated on the
rating plate corresponds to the actual
mains voltage.
• Mains lead should be minimum 1,5 m
long, so that it may be plugged into the
socket before the appliance is completely
pushed to the wall.
• Earthing wire should be installed in such
manner to be the last one pulled out in
case the safety relief device of the mains
lead should fail.
30
Instructions for use, installation and connection
Connection
• Using the screwdriver open the connector
cover at the rear of the appliance.
Release two locks located at either side of
the connector bottom.
• Mains lead must be led through the relief
safety device, protecting the mains lead
cable from disconnection.
• Connect the appliance according to one of
the illustrated possibilities. In case of
difference in voltage, the bridges should
be relocated!
• Tighten the relief device securely and
close the connector cover.
Colour code
L1, L2, L3 = exterior live wires, usually
coloured black, black, brown.
N = neutral
The colour is usually blue.
Beware of the correct N-connection!
PE = earthing wire
The colour is green/yellow.