Oven Drawer - Baumatic BT2385SS Instruction Manual

Removing oven door with a
single axe hinge
(certain models only)
Open the door completely and turn the
removable locks backwards (see fig). Then
close the door slowly and let the locks fit to
the notches. At an angle of about 15° lift the
door slightly up and pull the door from the
hinge supports (fig. 2).
For reinserting the door repeat the
procedure backwards. Insert the door at an
angle of about 15° into the hinge supports
by pushing them forward and downwards,
so the hinges lock into their slots (fig. 3).
Check if the hinges are locked into their
respective slots.
Now open the door completely and turn the
removable locks into their original position.
Close the door slowly and check if they
close properly (fig. 4). If you have trouble
closing the door, check if the hinges are
properly inserted into their slots.
Attention! Never let the hinge locks spring
out, as the springs are strong and may
cause injuries.
Instructions for use, installation and connection
Accessories
Accessories, like biscuit tray, oven grid, etc.
are cleaned with hot water and the usual
detergent.
Special enamel
Oven, interior door lining, baking tray and
grease interception pan are coated with
special enamel, with smooth and resistant
surface.
This special coating facilitates cleaning at
room temperature.
Grease filter
Clean the grease filter after each use with
soft brush in hot water with some detergent,
or wash it in the dishwasher.

Oven drawer

• The oven drawer is protected from
accidental opening.
• It may be open by lifting upwards. To
remove the drawer from the cooker pull it
out to the limit, then lift upwards and pull
out completely.
• Never place any flammable or explosive
substances in the drawer.
• The drawer is equipped with side slides
on wheels. To insert it back, slide the
wheels into the slide guides and push
inwards
25