Setting Data Hold/Refresh Hold Mode; Figure 4-1 Data Hold/Refersh Hold Setup - Agilent Technologies U1251A User's Manual And Service Manual

Setting Data Hold/Refresh Hold Mode

Agilent U1251A/U1252A User's and Service Guide
1. Set OFF to enable the Data Hold mode (manual trigger by
key or bus via the remote control).
2. Set the variation count within the 100 to 1000 range to
enable the Refresh Hold mode (auto trigger). When the
variation of the measuring value exceeds the setting of the
variation count the Refresh Hold will be ready to trigger.
Press
Press
Press

Figure 4-1 Data hold/Refersh hold setup

Changing The Default Setting
Press
Press
4
77