Setting Data Hold/Refresh Hold Mode; Figure 4-2 Data Hold/Refresh Hold Setup - Agilent Technologies U1253B User's And Service Manual

Setting Data Hold/Refresh Hold mode

U1253B User's and Service Guide
1 Set menu item RHOLD to "OFF" to enable Data Hold
mode (manual trigger by key or bus via remote control).
2 Set menu item RHOLD within the range of 100 to 9900 to
enable Refresh Hold mode (automatic trigger). Once the
variation of measured values exceeds this value (which is
the variation count), the Refresh Hold will be ready to
trigger and hold a new value.
Set all digits to ZERO
to set RHOLD to "OFF"
(enable Data Hold)

Figure 4-2 Data Hold/Refresh Hold setup

Changing the Default Settings
Press Hz
to edit
Press Hz to save
and exit
or press Esc
to exit without saving
4
Press or
to go to the digit
Press or
to edit the value
you want to edit
89