SETTING THE PASSWORD
USING THE PASSWORD TO ACCESS PROGRAM
If you want to change any program settings, you are required to enter the current
password first. "9999" will be displayed when you press the SELECT button before
entering.
Ex: Password "1234"
S
1
tep
TIME
SELECT
SELECT
S
2
tep
SELECT
TIME
SELECT
S
3
tep
Press the SELECT button. At that
moment "9999" is displayed and first
two digits flashes.
CHANGE
SET
In the example, press the
button to set at "12". And then press
the SET button.
At that moment, the flashing
changes to last two digits.
CHANGE
SET
In case of the example, press the
CHANGE button to set at "34". And
then press the SET button. At that
moment, the
"TIME".
CHANGE
SET
CHANGE
SET
Select desired setting mode by
pressing the SELECT button.
Then
explained.
CHANGE
mark indicates the
make
settings
as
20