HP Compaq MultiSeat ms6000 Troubleshooting Manual page 50

Table A-1 Numeric Codes and Text Messages (continued)
Control panel message
2202-PMM Deallocation Error during MEBx
cleanup
2203-Setup error during MEBx execution
2204-Inventory error during MEBx execution BIOS information passed to the MEBx
2205-Interface error during MEBx execution
2211-Memory not configured correctly for
proper MEBx execution.
Invalid Electronic Serial Number
Memory Parity Error
44 Appendix A POST Error Messages
Description
Memory error during POST execution of the
Management Engine (ME) BIOS Extensions
option ROM.
MEBx selection or exit resulted in a setup
failure.
resulted in a failure.
MEBx operation experienced a hardware
error during communication with ME.
DIMM1 is not installed.
Electronic serial number is missing.
Parity RAM failure.
Third-party graphics card may be causing a
problem.
Recommended action
1. Reboot the computer.
2. Unplug the power cord, re-seat the
memory modules, and reboot the
computer.
3. If the memory configuration was
recently changed, unplug the power
cord, restore the original memory
configuration, and reboot the computer.
4. If the error persists, replace the system
board.
1. Reboot the computer.
2. Unplug the power cord, re-seat the
memory modules, and reboot the
computer.
3. If the memory configuration was
recently changed, unplug the power
cord, restore the original memory
configuration, and reboot the computer.
4. If the error persists, replace the system
board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version.
3. If the error still persists, replace the
system board.
Make sure there is a memory module in the
black DIMM1 socket and that it is properly
seated.
Enter the correct serial number in Computer
Setup.
Run Computer Setup and Diagnostic utilities.
Remove third-party graphics card to see if the
problem goes away.
ENWW