Aastra Venture User Manual page 43

In order to communicate, all Venture
phones must share the same
telephone line as line 1.
1. To ensure that the same
telephone line is connected to
line 1 on all Venture phones you
can
• Press „.
• If you do not hear dial tone, see
"No dial tone" on page 37.
• If you hear dial tone, check
every Venture phone — the
„ indicator light
should be turned on.
• If the „ indicator light
is not turned on, verify that the
jacks are wired correctly and
the line cords are connected
correctly, see "Appendix" on
page 45.
2. Press ©.
3. Press '. For every Venture
phone in your system, the
38 Venture 3-Line Telephone User Guide
display should show the Name
assigned to the phone, Phone xx
and one of four possible status
messages:
• idle — the phone is not in use
• busy — the phone is in use
• owner — this is the phone you
are using
• ... — the phones aren't
communicating or that phone
has been removed from the
system
4. Call your phone from any
Venture phone that does not
appear in the Phone list.
5. If the call was placed
successfully, the phone will now
appear in the Phone list. Repeat
step 3 to verify.
6. If all the phones appear in the
Phone list, call each phone. If
you don't encounter problems,
you are finished. If your display
shows, Phone not responding
or you hear clicking noises, see
"Interference caused by non-
Venture phones or unused
telephone jacks" on page 38.
I I I I n n n n t t t t e e e e r r r r f f f f e e e e r r r r e e e e n n n n c c c c e e e e c c c c a a a a u u u u s s s s e e e e d d d d b b b b y y y y n n n n o o o o n n n n - - - - V V V V e e e e n n n n t t t t u u u u r r r r e e e e
p p p p h h h h o o o o n n n n e e e e s s s s o o o o r r r r u u u u n n n n u u u u s s s s e e e e d d d d t t t t e e e e l l l l e e e e p p p p h h h h o o o o n n n n e e e e j j j j a a a a c c c c k k k k s s s s
Some non-Venture equipment
connected to the telephone line that is
used as line 1 on your Venture
system can cause interference.
Follow these steps to eliminate those
problems:
1. Following the installation
instructions included with the
termination module, plug a
termination module into every
phone jack in your home or
office that is not used for a
Venture phone.
Note: Do not plug your
Venture phones into a
termination module.