Removing A Blower Module; Removing An I/O Module - IBM 8852 - BladeCenter H Rack-mountable Installation And User Manual

Removing a blower module

Your BladeCenter might be equipped with standard blower modules (part number
44E5083), or it might be equipped with high-efficiency blower modules (part number
68Y8205). The standard and high-efficiency blower modules are not
interchangeable and should not be mixed in the same BladeCenter unit.
To remove a blower module, complete the following steps.
1. Read the safety information that begins on page v and "Installation guidelines"
2. Press the release button on the blower handle and rotate the handle to the
3. Using the handle, pull the blower module out of the bay.

Removing an I/O module

To remove an I/O module or module filler, complete the following steps.
1. Read the safety information that begins on page v and "Installation guidelines"
22
BladeCenter H Type 8852, 7989, and 1886: Installation and User's Guide
Release button
on page 18.
open position (rotate to the right for the upper blower module or to the left for
the lower blower module).
I/O
module
Release handle
(open)
on page 18.
Handle (open)
Single
module
filler
Module
filler
Double
module
filler
I/O module
Release handles
(open)