Removing Components Before Rack Installation; Removing A Power Module - IBM 8852 - BladeCenter H Rack-mountable Installation And User Manual

v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it immediately without setting
v Take additional care when handling devices during cold weather. Heating reduces

Removing components before rack installation

Attention:
removing components from the BladeCenter unit when the unit is connected to
power.
Use the following procedures to remove components from the BladeCenter unit
before you install it in a rack and connect to power.

Removing a power module

To remove a power module, complete the following steps.
1. Read the safety information that begins on page v and "Installation guidelines"
2. Press the blue release button on each end of the bezel.
3. Pull the bezel away from the BladeCenter unit.
metal part of the BladeCenter unit or rack for at least 2 seconds. This drains
static electricity from the package and from your body.
down. If it is necessary to set down the device, put it back into its
static-protective package.
indoor humidity and increases static electricity.
See the BladeCenter H Problem Determination and Service Guide for
Release buttons
Release buttons
on page 18.
Chapter 3. Installing the BladeCenter unit and options
19