Removing A Blower Module; Installing A Blower Module - IBM eServer BladeCenter T8720 Installation And User Manual

Removing a blower module

Use the following instructions to remove a blower at the rear of the BladeCenter T
unit.
1. Press the release lever at the end of the release latch and pull the latch to the
2. Slide the module out of the blower bay and set it aside.
3. Within 1 minute, install another blower module into the bay.

Installing a blower module

Complete the following steps to install a blower module into the rear of the
BladeCenter T unit.
1. Press the release lever at the end of the release latch and pull the latch to the
2. Insert the blower into the selected blower bay.
3. Push the blower module into the bay until it stops. The release latch moves
4. Close the release latch until it locks into position.
5. Make sure that the blower power LED is lit and the blower error LED is not lit.
4
2
open position. The blower module moves slightly out of the bay.
open position.
slightly toward the closed position.
Chapter 3. Removing and installing BladeCenter T modules and options
Error LED
3
1
Power LED
Release latch
(open)
39