Installing A Management Module - IBM 8852 - BladeCenter H Rack-mountable Installation And User Manual

Installing a management module

To install a management module, complete the following steps.
1. Remove the module filler if one is installed.
2. Make sure that the release handle on the module is in the open position.
3. Slide the module into the module bay until it stops.
4. Push the release handle on the module to the closed position.
5. Connect any cables to the module.
6. If the BladeCenter unit is connected to power:
26
BladeCenter H Type 8852, 7989, and 1886: Installation and User's Guide
Management
module
v Make sure that the OK LED on the module is lit.
v If this is a redundant management module, wait at least 45 minutes for the
modules to copy.
Module
filler
Release handle
(open)