Management-Module Error Messages - IBM 8677 - BladeCenter Rack-mountable - Power Supply Hardware Maintenance Manual And Troubleshooting Manual

Note: See Chapter 7, "Parts listing, BladeCenter Type 8677 and 1881," on page 77 to determine which components
should be replaced by a field service technician.
Message
Switch module%d IP configuration was
changed
ENET [X] DHCP HSTN=X, DN=X, IP @=
XXX.XXX.XXX.XXXGW @=
XXXX.XXX.XXX.XXX, SN=
XXX,XXX,XXX,XXX, DNS1@=
XXX.XXX.XXX.XXX
ENET [X] IP Cfg:HstName= XXXX, IP@=
XXX.XXX.XXX.XXX ,GW@=
XXX.XXX.XXX.XXX, NetMsk=
XXX.XXX.XXX.XXX Switch module x was
installed
LAN: Ethernet [x] interface is no longer
active
LAN: Ethernet [x] interface now longer
active

Management-module error messages

Note: See Chapter 7, "Parts listing, BladeCenter Type 8677 and 1881," on page 77 to determine which components
should be replaced by a field service technician.
Message
Application posted alert to ASM
System log 75% full
System log full
Management module network
initialization complete
Remote login successful. Login ID
ASM reset was caused by restoring
default values
ASM reset was initiated by the user
Pushbutton reset activated: Ethernet
configuration reset to default values and
MM ASM reset due to watchdog timeout
ASM reset due to XXXXX, instruction
fault: XXXXXXXX YYYYYYYY ZZZZZZ
ASM reset reason unknown
Possible ASM reset occurred reason
unknown
Remote access attempt failed. Invalid
userid or password received. User is
XXX from CMD mode client at
IP@=XXX.XXX.XXX.XXX
Action
Information only. Take action as required.
Ethernet configuration information. Take action as required.
Ethernet configuration information. Take action as required.
Check cables to I/O module.
Information only. Take action as required.
Action
The alert button on the Web interface was tested. Information only.
Take action as required.
Information only. Take action as required.
Information only. Take action as required.
Information only. Take action as required.
Information only. Take action as required.
The management-module assembly was reset after restoring the
default settings. Information only. Take action as required.
Information only. Take action as required.
1. Reseat the management module.
2. Reflash the management-module firmware.
3. Replace the management module.
1. Reseat the management module.
2. Reflash the management-module firmware.
3. Replace the management module.
Information only.
Information only.
Failed attempt to log into the management module.
Chapter 6. Symptom-to-FRU index
73