Optical Or Diskette Drive - IBM 8677 - BladeCenter Rack-mountable - Power Supply Hardware Maintenance Manual And Troubleshooting Manual

Reverse these instructions to reinstall the media tray cover. Press the rear of the
cover down onto the two fasteners to secure the cover in place.

Optical or diskette drive

Note: The diskette drive is not present in all BladeCenter unit models.
The optical drive and the diskette drive have the same securing mechanism, a
wire-retention spring. On the optical drive, the wire spring is on the left; on the
diskette drive, the wire spring is on the right.
Complete the following steps to replace the optical drive or the diskette drive.
Note:
v Read "Installation guidelines" on page 31.
v Read the safety notices at "Safety information" on page 85.
v Read "Handling electrostatic discharge-sensitive devices" on page 88.
Lift points
1. Remove the media tray (see "Media tray" on page 48).
2. Remove the media-tray cover (see "Removing the media-tray cover" on page
48).
Drive guide
Wire spring
Retention hook
Drive guide
Tabs
Pressure points
Slots
CD-ROM drive Diskette drive
Chapter 5. Service replaceable units
Drive guide
Wire spring
Retention hook
Drive guide
49