Media Tray; Removing The Media Tray; Removing The Media-Tray Cover - IBM 8677 - BladeCenter Rack-mountable - Power Supply Hardware Maintenance Manual And Troubleshooting Manual

Media tray

This section describes removing and opening the media tray.

Removing the media tray

Complete the following steps to remove the media tray.
Note:
v Read "Installation guidelines" on page 31.
v Read the safety notices at "Safety information" on page 85.
v Read "Handling electrostatic discharge-sensitive devices" on page 88.
1. Remove the BladeCenter bezel.
2. Push the tabs on the left and right sides of the tray to the left and right
Reverse these instructions to reinstall the media tray.

Removing the media-tray cover

Complete the following steps to remove the media tray cover.
Note:
v Read "Installation guidelines" on page 31.
v Read the safety notices at "Safety information" on page 85.
v Read "Handling electrostatic discharge-sensitive devices" on page 88.
1. Lift at the points indicated in the illustration to lift the rear of the tray cover off
2. Slide the cover toward the rear of the tray until the front tabs are clear of the
48
BladeCenter E Type 8677 and 1881: Hardware Maintenance Manual and Troubleshooting Guide
a. Press the release pads at the bottom corners of the bezel.
b. Swing the bezel up and off the BladeCenter.
respectively; then, pull the media tray out of the BladeCenter.
the fasteners.
slots in the tray; then, lift the cover off the tray.
Note: The diskette drive shown in the following illustration is not present in all
BladeCenter unit models.