Installing an LCC Module
Figure 3-22
The LCC Active light turns on. The activity lights of any affected
disk modules should resume a steady flicker. If the disk activity
lights do not flicker within 6 seconds, remove the LCC and insert
it again.
2. If you are installing a replacement LCC, reattach the copper cable
on the EXP connector, if required, as shown next.
Servicing and Upgrading a DPE
Latch up
A.
Pull up the latch on the LCC.
B.
Align the LCC with the guide
on the slot.
C.
Gently slide the LCC into the
slot.
D.
Push down the latch until
the LCC is fully seated in
the slot.
Latch down
Replacing or Adding an LCC Module
3
3-33