Removing The Memory Module From The Sp - Dell FC4500 Hardware Reference Manual

A. Use your thumbs
to push out on the
locking tabs, and
use your fingers to
lift the DIMM
upward until it
releases from the
tabs.
B. Lift the module out
of the connector,
and place it in its
own antistatic
packaging.
Figure 3-16

Removing the Memory Module from the SP

After removing the memory module, if you want to ship the SP, store
it in its antistatic bag and special shipping package. Then remove and
store the ESD wristband.
Installing an SP
Depending on the memory size (in megabytes), the SP memory module can
Memory Module
contain chips on only one side or on both sides.
1. Place the SP and the memory module (DIMM) on a static-free
2. On the SP, install the DIMM in the appropriate connector as
Locking tabs
work surface.
shown next.
A memory module has a notch on its edge near pin 1 so that you can
insert it only one way. Install memory modules one at a time, and in
order, starting with connector 1 (refer to Figure 3-17).
Installing or Replacing an SP Memory Module
Servicing and Upgrading a DPE
Locking tabs
Alignment
notch
3
3-25