2. At the back of the deskside DPE, gently insert the SP or filler
module as shown below.
Ejector
(one each side)
Installing an SP or SP Filler Module
Figure 3-19
Servicing and Upgrading a DPE
A. Open the ejectors as far as
possible; then gently push
the module into the
enclosure guides,
supporting it at both sides.
B.
Close both ejector handles
simultaneously to fully seat
the SP module.
Retaining screw
(one each side)
C. Tighten the retaining
screws.
Installing an SP or SP Filler Module
3
3-29