Removing a
Power-Supply Filler
Module
Bottom filler module
A.
Figure 3-26
If one power supply is off and the other is on, do not turn one on and
immediately turn off the other. Instead, turn one on and wait five seconds
before turning the other off.
If you are adding a new power supply, remove the power-supply
filler module as shown next. If you are replacing a faulty power
supply, remove the power-supply module itself as follows.
1. Remove the drive fan pack as shown on page 3-35.
2. Remove the filler module as shown in Figures 3-26 and 3-27.
Latch
(one per side)
Push each latch of the filler
module toward the center.
Removing the Bottom Filler Module
B.
Replacing or Adding a Power-Supply Module
Servicing and Upgrading a DPE
Pull the filler module
from its slot.
3-37
3