Settings Button - Kodak Ngenuity 9090DB User Manual

Settings button

3-12
Resetting the maintenance reminders
If a component's maintenance interval expires triggering the
maintenance reminders, a hyperlink for that component will navigate
you to reset and restart the interval count. This process is necessary to
ensure required maintenance continues to be monitored appropriately.
NOTE: The alerts for calibrating the front and back cameras cannot be
adjusted. If an alert to calibrate the camera(s) is displayed, click
the corresponding hyperlink to reset the reminder and begin
calibration. For procedures on calibrating the cameras, see
Chapter 5, Maintenance.
When you click the Settings button on the Ngenuity Operator Utility
main screen, the Configure Scanner Settings screen will be displayed.
You can configure basic scanner settings (e.g., Sleep timeout, Multifeed
range, Custom Functions and Audio volume and sound) using this
screen.
Sleep timeout — you can set the delay time in hours and minutes that
the scanner can be idle with full power before going into "sleep" mode.
The default timeout is 15 minutes; the maximum time is 4 hours.
Multifeed — allows you to adjust the sensitivity when scanning Normal
or Very thin documents.
• Normal: for documents that range from thick card stock to thin
carbon copies. This setting should be used for most documents.
• Very thin: used to detect multifeeds when scanning ultra-thin
documents such as rice paper.
A-61662 April 2010