Kodak Ngenuity 9090DB User Manual page 49

5-10
Cleaning the sensors
There are 7 sensors that require regular cleaning. Use only the
supplied blower brush to clean these sensors. Do not use any type of
cotton swab or cloth as these items may leave lint in the sensors.
NOTE: If problems persist after cleaning the sensors, it may be
necessary to use forced air to clean the sensors. If using forced
air, use the extension tube on the can to spray the forced air. Do
not turn the can upside down or tip it sideways.
10. Feeder sensor: Place the brush end of the blower brush into the
feeder sensor area and squeeze the blower brush several times to
clean the feeder sensor on the feeder table.
11. Gap sensor, page entry sensors and pass thru sensor: Open
the transport cover to clean these 5 sensors by placing the brush
end of the blower brush into the each sensor area and squeeze the
blower brush several times to clean.
Top or front page tray assembly
Feeder sensor
Gap sensor
Page entry
sensors (3)
Pass thru
sensor
A-61662 April 2010