Download  Print this page

Adding Or Removing The Dds-2 Drive Bezels Or Expansion Brackets; Adding A Bezel To The Dds-2 Drive - HP Model 705 - Workstation User Manual

Hp dds-2 tape drive user's guide (a1658-90701)
Hide thumbs

Advertisement

Adding or Removing the DDS-2 Drive Bezels or Expansion Brackets

Depending on the size of the drive opening in your system, you may need to add or
remove a bezel or expansion brackets to ensure that your DDS-2 drive fits in your
system.
Part numbers for the HP bezels are as follows:
C1534–60117 – 3 1/2 inch Dove Grey
C1534–60226 – 5 1/4 inch Dove Grey
C1534–60116 – 3 1/2 inch Flint Grey
C1534–60225 – 5 1/4 inch Flint Grey
NOTICE:
Before performing any of these changes, make sure there is not a
cassette in the drive.
To add a bezel (it can be a 3.5-inch bezel, or a 5.25-inch bezel) to your drive, push the
bezel onto the drive, making sure the tabs click into place. Refer to Figure 1–5.
Figure 1–5. Adding a Bezel to the DDS-2 Drive
Introduction
1–15

Advertisement

Table of Contents
loading

  Also See for HP Model 705 - Workstation

  Related Manuals for HP Model 705 - Workstation