Download  Print this page

Removing And Replacing The Dds-2 Drive; Adding Or Removing The Dds-2 Drive Bezels And Expansion Brackets - HP Model 705 - Workstation User Manual

Hp dds-2 tape drive user's guide (a1658-90701)
Hide thumbs

Advertisement

Troubleshooting and Removal/Replacement Procedures

Removing and Replacing the DDS-2 Drive

To open your system, remove and reinstall the DDS-2 drive, refer to the Owner's Guide
that came with your system. Read "Preparing to Install the DDS-2 Drive" in Chapter 1 of
this guide before beginning an installation.

Adding or Removing the DDS-2 Drive Bezels and Expansion Brackets

Depending on the size of the drive opening in your system, you may need to add or
remove a bezel or expansion brackets to ensure that your DDS-2 drive fits in your
system.
NOTICE:
Before performing any of these changes, make sure there is not a
cassette in the drive.
To add a bezel (it can be a 3.5-in bezel, or a 5.25-in bezel) to your drive, push
onto the drive, making sure the tabs click into place. Refer to Figure 3–1.
To remove a bezel from a drive, use a straight blade screwdriver to lift the bezel
tabs from the sides of the drive. Refer to Figure 3–2.
To add or remove expansion brackets to the drive, use a T10 torx wrench to ei-
ther tighten or remove the four torx screws that hold each expansion bracket to
the drive. Refer to Figure 3–3.
3–10

Advertisement

Table of Contents
loading

  Also See for HP Model 705 - Workstation

  Related Manuals for HP Model 705 - Workstation