Download  Print this page

Removing A Bezel From The Dds-2 Drive; Adding Or Removing Expansion Brackets - HP Model 705 - Workstation User Manual

Hp dds-2 tape drive user's guide (a1658-90701)
Hide thumbs

Advertisement

Introduction
To remove a bezel from a drive, use a straight blade screwdriver to lift the bezel tabs
from the sides of the drive. Refer to Figure 1–6.
Figure 1–6. Removing a Bezel from the DDS-2 Drive
To add expansion brackets to the drive or to remove them, use a T10 torx wrench to
either tighten or remove the four torx screws that hold each expansion bracket to the
drive. Refer to Figure 1–7.
Figure 1–7. Adding or Removing Expansion Brackets
1–16

Advertisement

Table of Contents
loading

  Also See for HP Model 705 - Workstation

  Related Manuals for HP Model 705 - Workstation