User Options; Control Panel Lock And Unlock; Fahrenheit Or Celsius Selection; Beeper Volume Selection - Alto-Shaam 300-TH/III Installation & Operation Manual

U S E R O p T I O N S
Lock
indicator
P Keys Lock and Unlock
reseT
p Keys A through H can be locked in order to
reset
prevent storing, altering or erasing a program.
To lock the P Keys, press and hold the "I"
reset
Key until the oven beeps. Release the "I" key. The
green indicator on the "I" key will illuminate. Oven
p Keys A through H are now locked.
reset
Note: Only the oven p
affected by this lock-out in order to also allow
the oven to be used with the unprogrammed
Cook, Probe, or Hold modes.
To unlock the P Keys, press and hold the
reset
c Key along with the "I" Key for two seconds
ancel
until the "I" key light no longer illuminates. Release
all keys. The oven preset keys are now unlocked.

Fahrenheit or celsius Selection

With the control in the off mode,
press and hold the u
p
the display shows the current selection.
Press the up or down buttons to toggle
between the two options. After each
change the button must be released. The
display must clear before the procedure
can be repeated.
O p E R A T I O N
keys A through H are
reset
a Key until
rrow
TH/III
InsTallaTIon

control panel Lock and Unlock

The control panel can be locked at any time in order to
prevent inadvertent or accidental setting changes.
To lock the control panel, press and hold the
u a Key and then press the O
p rrow
You will hear a brief beep and the panel lock
indicator will illuminate. Release all keys.
The oven's control panel is now locked.
note: The control panel is now fully locked with the
exception of the O
You will be unable to turn the oven control off at
this point.
To unlock the control panel, press and hold the d
a Key and then press the O
rrow
will hear three beeps and the panel lock indicator will
extinguish. Release all keys. The panel is now unlocked
and ready for normal use.

Beeper Volume Selection

With the control in the off mode, press
and hold the d
own
the display shows one of the 4 volume
levels (0 being
off
3 being the highest). After each change,
the button must be released and the
display must clear before the procedure can be
repeated to select a different volume level.
Turn the unit
on
desired set point.
/ /
operaTIon servIce manual
preset
Lock
/O
N ff
/O Key and a
N ff rrow
/O Key. You
N ff
a Key until
rrow
or the lowest, and
and then again to store the
off
Key.
keys.
own
. 21
pg