Allied Telesis Patch 89262-08 Release Note page 3

Patch 89262-08 For AT-8900 Series Switches
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H
PCR: 40596 Module: SWMX
When STP is enabled, when frames with a multicast destination MAC
address were sent, a loop was observed within the network. This issue has
been resolved.
PCR: 40601 Module: SWMX
In network configurations with multiple paths to neighbours on an
interface, if the interface changed state from up to down, then up again, the
interface route may have been erroneously deleted by a route update. This
issue has been resolved.
PCR: 40619 Module: IPG
The valid and preferred parameters were incorrectly added to the dynamic
set ipv6 prefix configuration. The default onlink and autonomous
parameters were also being included. This issue has been resolved.
Level 3
PCR: 40589 Module: IPG
The counter parameter did not exist in the show igmpsnooping command.
This issue has been resolved.
PCR: 40603 Module: SWI, SWMX
An error message is now shown if the user tries to assign more than the
allowable number of traffic class (or default traffic class) entries to active
QOS policies.
PCR: 40606 Module: VLAN
When a Core port was added to a nested VLAN, its Ingress Filtering
attribute was set to be On and Acceptable Frame Type was set to be Admit
Only VLAN tagged Frames. If the port was deleted from that VLAN, its
Ingress Filtering attribute must be set to Off and Acceptable Frame Type
must be set to Admit All Frames, however, the attributes were not changed
when the port was deleted from the nested VLAN. This issue has been
resolved.
PCR: 40617 Module: TTY
The manager prompt did not appear when using a telnet session until the
[Enter] key was pressed several times. This issue has been resolved.
PCR: 40618 Module: SWI
An FTP server located on a private interface of a firewall with NAT enabled
may have had its ftp-data (tcp/20) source port translated to another port.
This could lead to a firewall rejecting the data packets, as they do not strictly
conform to RFC 959. This issue has been resolved, ensuring that ftp-data
packets are sent from port 20 on the firewall, even when NAT is enabled.
3
Level: 2
Level: 2
Level: 2
Level: 3
Level: 3
Level: 3
Level: 3
Level: 3