Allied Telesis Patch 89262-08 Release Note page 10

10
PCR: 40498 Module: OSPF
When a virtual link end point is no longer reachable, the virtual interface is
not brought down, and the virtual neighbour is not removed. This issue has
been resolved.
PCR: 40515 Module: QoS
Setting switch enhanced mode to "none" in order to disable QoS counters
did not disable the QoS counters properly. A debug error message was
shown when attempting to view the traffic class counters. This debug error
message has now been removed and an appropriate error message is now
displayed.
PCR: 40525 Module: SWI, SWX
When MIB counters relating to packet flows reached their maximum
possible value (0xFFFFFFFF), they should have returned to 0, and counted
up from 0 again. However, they were remaining stuck at 0xFFFFFFFF.
This issue has been resolved, so that the counters will correctly roll over
from 0xFFFFFFFF to 0 and start counting up again.
Level 4
No issues.
Enhancements
PCR: 40511 Module: RSTP
The RSTP module has been enhanced to detect simple loop scenarios
downstream of an RSTP enabled edge port. If a loop is detected, the port is
placed into a Backup/Discarding/LoopbackDisabled state. In this state, all
packets are discarded. The port transitions to a Designated/Discarding
state after 3 x helloPeriod. If the loop still exists, the Backup/Discarding/
LoopbackDisabled state is repeated.
PCR: 40521 Module: TACACS+
The new command show tacplus has been added. This command shows the
module status, number of servers, and number of logged in users.
Patch Release Note
Level: 3
Level: 3
Level: 3
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H