Download Print this page

Allied Telesis Patch 89262-08 Release Note page 14

89262-08 patch release note

Advertisement

14
PCR: 40431
Module: SWMX
When the IPV6 accelerator card was present but disabled, the switch was
not transmitting CPU-initiated packets after receiving non-reserved
multicast packets. This issue has been resolved.
PCR: 40433
Module: VLAN
When the nested VLAN feature was disabled using the disable feature
command, the switch did not remove, from software and hardware, all of
the nested VLAN's associated ports, protocols and subnets as well as the
nested vlans. This issue has been resolved.
PCR: 40440
Module: CLASSIFIER
For those classifiers that specified the IP protocol as a match criterion, the IP
protocol number was being stored and displayed in a configuration file as a
hexadecimal value rather than a decimal value. This issue has been
resolved.
PCR: 40441
Module: IPG, VRRP
If VRRP was enabled and a reset ip command was issued followed by a
disable vrrp command, then the device would still reply to pings, even
though the device was no longer the VRRP master. Duplicate echo replies
were seen on the device sending the pings. This issue has been resolved.
PCR: 40446
Module: DHCP
In certain situations, if a DHCP client used a DHCP relay agent to request
IP addresses from the switch acting as the DHCP server on a different
subnet, it was not be able to renew the IP address allocated to it. This issue
has been resolved.
PCR: 40453
Module: IPG
Particular IP packets (unicast destination IP, but multicast destination
MAC) could result in a memory leak, which in some cases could cause the
device to stop responding to the command line. This issue has been
resolved.
PCR: 40454
Module: SWNP
The enable/disable switch accelerator commands could be executed even
though no IPv6 accelerator card was installed. This issue has been resolved.
PCR: 40458
Module: IPG
The switch was accepting network RIP packets from foreign subnets. This
issue has been resolved.
Patch Release Note
Level: 2
Level: 2
Level: 3
Level: 4
Level: 2
Level: 2
Level: 3
Level: 2
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H

Advertisement

loading

This manual is also suitable for:

At-8900 series