Allied Telesis Patch 89262-08 Release Note page 19

Patch 89262-08 For AT-8900 Series Switches
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H
PCR: 40249 Module: SWI, SWMX
Fibre SFPs can now be set to a fixed speed. Copper SFPs still can not have
their speed parameters modified.
PCR: 40270 Module: PIM6
The maximum number of PIM6 interfaces has been increased from 255 to
2000. The number of MLD interfaces has also been increased to 2000 to
match the maximum number of PIM interfaces.
PCR: 40274 Module: VLAN, RMON
In SNMPv2c the histroyControlBucketsGranted value was outside the
acceptable range. This issue has been resolved.
PCR: 40277 Module: IPG
BGP routes were not always readvertised to peers after a next-hop route
was lost and then reactivated. This issue has been resolved.
PCR: 40289 Module: IPG, IPV6
The device's own MAC address was accepted as the next hop MAC address
when adding a static IP ARP entry with the add ip arp command, or an IPv6
neighbour with the add ipv6 nd command. This issue has been resolved.
PCR: 40290 Module: IPG
An incorrect nexthop for a RIP route was advertised in RIP messages. This
issue has been resolved.
PCR: 40299 Module: IPG
When the most recently added VLAN was deleted, the switch did not
respond correctly to subsequent DHCP Discover messages. This issue has
been resolved.
PCR: 40301 Module: SWMX
The value for the Device rule space limit in the output of the show switch
command was incorrect. This issue has been resolved.
PCR: 40302 Module: SWI, SWNP
Incorrect options were returned with "?" help for the show switch
accelerator command. This issue has been resolved.
PCR: 40307 Module: SSL
A memory leak sometimes occurred when many HTTPS sessions (using
SSL) were load balanced. This issue has been resolved.
PCR: 40310 Module: IPV6
The incorrect parameter ipaddress was returned with "?" help for the
delete ipv6 host=name command. This issue has been resolved.
PCR: 40312 Module: IPV6
IPv6 packets travelling through a 6-to-4 tunnel were sent to an incorrect
IPv4 end address, although the first packet was sent correctly. This issue has
been resolved so that all packets are sent to the correct address.
19
Level: 3
Level: 2
Level: 2
Level: 3
Level: 2
Level: 3
Level: 3
Level: 2
Level: 3
Level: 2