Kyocera C8100DN - Color Laser Printer Operation Manual page 41

Advanced > Protocols > TCP/IP > Logical Printers
Operation Guide
If nothing is specified on this page, access from all hosts is allowed.
Item
IP Filter (IPv4)
IP Address
(IPv4)
Subnet
Mask
Protocols
IP Filters (IPv6)
IP Address
(IPv6)
Prefix
Length
Protocols
This page allows you to configure the Logical Printers. This machine can be used as a
virtual printer for converting ASCII print data to PostScript data or for adding and/or
replacing a character strings (commands) at the beginning or end of job data. Up to four
logical printers can be set.
Description
Specifies the IP address or network address to be permitted.
The number of specifiable entries differs depending on
models.
Specifies the subnet mask to be permitted.
To permit access from all hosts on network 192, enter
"192.0.0.0" for the IP address and "255.0.0.0" for the subnet
mask.
Subnet mask can be left blank.
Specifies the protocol to be permitted. The following
protocols can be selected.
- LPD
- FTP
- IPP
- HTTP
- SNMP
- RAW Port
- IPP over SSL
- HTTPS
Specifies the IP addresses to which access is granted. The
number of addresses that can be specified varies depending
on the model used.
Specifies the IPv6 prefix length. It can be a decimal value
between 0 and 128.
Specifies the protocols through which access is granted.The
following protocols can be selected.
- LPD
- FTP
- IPP
- HTTP
- RAW Port
- SNMP
COMMAND CENTER Pages
37