Snmp Group - TP-Link TL-SL2428 User Manual

View Table

Select:
View Name:
View Type:
MIB Object ID:

10.1.3 SNMP Group

On this page, you can configure SNMP Group to control the network access by providing the users
in various groups with different management rights via the Read View, Write View and Notify View.
Choose the menu SNMP→SNMP Config→SNMP Group to load the following page.
The following entries are displayed on this screen:
Group Config

Group Name:
Security Model:
Select the desired entry to delete the corresponding view. All
the entries of a View will be deleted together.
Displays the name of the View entry.
Displays the type of the View entry.
Displays the OID of the View entry.
Figure 10-5 SNMP Group
Enter the SNMP Group name. The Group Name, Security Model
and Security Level compose the identifier of the SNMP Group.
These three items of the Users in one group should be the same.
Select the Security Model for the SNMP Group.

v1: SNMPv1 is defined for the group. In this model, the
Community Name is used for authentication. SNMP v1 can be
configured on the SNMP Community page directly.

v2c: SNMPv2c is defined for the group. In this model, the
Community Name is used for authentication. SNMP v2c can be
configured on the SNMP Community page directly.

v3: SNMPv3 is defined for the group. In this model, the USM
mechanism is used for authentication. If SNMPv3 is enabled,
the Security Level field is enabled for configuration.
105