Table of Contents
Advertisement
LYNXR-i Installation and Setup Guide
C o n t r o l
SYMPTOM
1.
The word "AC" is not
displayed.
2.
Digital communicator
message not being
received.
3.
Does not arm properly.
READY light not on.
4.
System doesn't respond to
keystrokes on keypad.
4a. "CC" displayed.
4b. "d1" displayed.
Smoke Detectors
SYMPTOM
1.
Detector alarms, no
apparent reason.
2.
Detector's siren sounds.
POSSIBLE CAUSE
1a. Interrupted AC power supply.
2a. System in Test mode.
2b. Telephone connection not secure.
2c. Digital communicator
malfunctioning.
2d. Telephone number in program needs
prefix or access code.
2e. Telephone call to central monitoring
station requires operator assistance.
Open or faulted zone(s)
4a. System is in communication with
downloader at central station.
4b. System has just been powered and is
in its one minute initialization.
POSSIBLE CAUSE
1a. Dust, dirt in sensing chamber.
1b. Improper location.
1c. Unit malfunctioning.
2a. Unit not receiving required power.
2b. Unit malfunctioning.
- 61 -
Troubleshooting Guide
REMEDY
1a. Check transformer connection and
powerline circuit breaker.
2a. Remove from Test mode.
2b. Check all connections.
2c. Check with a different CONTROL
PANEL.
2d. Program prefix or access code into the
CONTROL PANEL.
2e. System cannot work in this situation.
Check for faulted zones and make intact,
or use Bypass arming, if desired.
4a. Wait until download session is
finished.
4b. Wait for initialization to finish, or
bypass this time by pressing '#' + '0.'
REMEDY
1a. Clean unit's sensing
chamber with vacuum
cleaner per unit's
instructions.
1b. See unit's instructions
for locations to avoid.
Relocate as necessary.
1c. Replace detector.
2a. Check for proper
installation of battery.
Try new battery.
2b. Replace detector.
Hide quick links:
Advertisement
Table of Contents
