System Communication - Honeywell WAVE2EX - Ademco Two Tone Siren Installation And Setup Manual

Self-contained, rechargeable wireless control/communicators

Hide thumbs

Table Of Contents

Table of Contents

This section provides an explanation of formats this system accommodates for reporting alarms and other

system conditions to the central station. The process of a successful transmission consists of both the

method of communication between the control panel and the central station receiver, and the actual way the

information is sent and displayed at the central station.

Communication Overview

When the panel calls the central station receiver, it waits to hear a "handshake" frequency from the receiver

to confirm that the receiver is on-line and ready to receive its message. Once the panel hears the handshake

it is programmed to listen for, it sends its message. The panel then waits for a "kissoff" frequency from the

receiver acknowledging that the message was received and understood.

If the handshake frequency is not given or is not understood by the panel, the panel will not send its

message. Once the handshake frequency is received and understood by the panel, the panel will send its

message. If there is an error in the transmission (the receiver does not receive a "valid" message), the kissoff

frequency will not be given by the central station receiver.

The panel will make eight attempts to the primary telephone number and eight attempts to the secondary

telephone number (if programmed) to get a valid message through. If the panel is not successful after its

numerous attempts, the keypad will display "FC." If the secondary number is a pager, "FC" displays after

the first 8 attempts to the primary number.

The following chart defines the three sets of (handshake/kissoff) frequencies that the panel supports, and the

different formats that can be sent for each.

FORMAT

Low Speed

3+1

4+1

4+2

Sescoa/Rad

3+1

4+1

4+2

Express

4+2

Contact ID®

Report Code Formats

3+1 and 4+1 Standard Formats

3+1 and 4+1 Expanded Formats Comprise a 3- (or 4-) digit subscriber number, and a 2-digit report code.

4+2 Format

ADEMCO Contact ID®

Reporting Format

The following table shows the message formats for 3+1, 4+1 and 4+2 reports, where:

SSS or SSSS = Subscriber ID

A = Alarm Code (1st digit)

Z = Typically Zone Number* (2nd digit)

T t = Trouble Code (1st & 2nd digits)

B b = Bypass Code (1st & 2nd digits)

E A C = AC Loss Code (1st & 2nd digits)

L L B

= Low Battery Code (1st & 2nd digits)

O = Open Code (1st Digit)

*Zone numbers for: [

] & [#] = 99; [1] + [

HANDSHAKE

TRANSMITS DATA

1400Hz

1900Hz (10PPS)

(Standard report)

2300Hz

1900Hz (20PPS)

(Standard report)

1400–2300Hz

DTMF (10 cps)

1400–2300Hz

DTMF (10 cps)

Comprise a 3- (or 4-) digit subscriber number and a single digit report

code (e.g. alarm, trouble, restore, open, close, etc).

The first digit is displayed on the first line, followed by a second line

where the first digit is repeated 3 (or 4) times and followed by the

second digit. This is the "expanded" digit.

Comprises a 4-digit subscriber number and 2-digit report code.

Comprises a 4-digit subscriber number, 1-digit event qualifier

("new" or "restore"), 3-digit event code, and 3-digit zone number, user

number, or system status number (see the following page).

] = 95; [3] + [#] = 96; Duress = 92

LYNXR-I Installation and Setup Guide