Honeywell WAVE2EX - Ademco Two Tone Siren Installation And Setup Manual page 28

LYNXR-I Installation and Setup Guide
Data Field Descriptions
DOWNLOAD INFORMATION (
✻ Download Call Back Phone Number
94
Enter up to 20 digits as follows: 0–9, # +11 for "
+ 12 for "#", # + 13 for a pause.
✻ Ring Detection Count For Downloading/
95
Remote Phone Control
0 = disable station initiated download and remote
phone
1-14 = number of rings before control picks up phone
line
15 = defeat answering machine
OTHER PROGRAMMING COMMANDS
✻ 56
ENHANCED ZONE PROGRAMMING MODE
Interactive menu mode used for programming zone attributes and report codes. Refer to the
Enhanced Zone Programming Mode section for procedure.
✻ 80
DEVICE PROGRAMMING MENU MODE
Interactive menu mode for programming Powerline Carrier Devices. Refer to the
Programming Menu Mode section for detailed procedure.
✻ 81
ZONE LISTS MENU MODE
Interactive menu mode for programming zone lists for Powerline Carrier Devices. Refer to the
Zone List Menu Mode section for detailed procedure.
✻ 83
ENHANCED SEQUENTIAL MODE
Interactive menu mode used to enter RF transmitter serial numbers. Refer to the
Sequential Mode section for detailed procedure.
✻ 84
ASSIGN ZONE VOICE DESCRIPTORS
Interactive menu mode used to assign descriptors to each zone. These descriptors will be announced
whenever the system announces an event involving a zone.
✻ 85
RECORD CUSTOM VOICE DESCRIPTORS
Interactive menu mode used to record custom descriptors for use with each zone.
✻ 96
INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. NO. FOR
DOWNLOADING
✻
Pressing 96 initializes the system for downloading.
✻ 97
SET ALL PROGRAM FIELDS TO 1 OF 4 SETS OF DEFAULT VALUES
See Default Tables at the end of this manual.
✻ 98
EXITS PROGRAMMING MODE
Prevents re-entry by: Installer Code + 8 + 0 + 0; allows re-entry only by Power-up, then [
✻ 99
EXITS PROGRAMMING MODE
Allows re-entry to program mode by: Installer Code + 8 + 0 + 0; or by Power-up, then [
✻ ✻
94, 95)
This is the phone number the control will use to call back the downloading
computer.
*
", #
Do not fill unused spaces. End field by pressing
field, press
Enter "15" to select defeat answering machine mode. If an
answering machine is on the premises, you need to dial the
premises and hang up on the first ring. Wait at least five (5)
seconds (but no more than 22 seconds) and dial the premises
phone number again. The control will pick up and announce
"SYSTEM ENTER CODE" every three seconds.
Note: To enter a number higher than 9 you must first press the [#] key.
- 28 -
✻ ✻
94 .
✻
80 Device
✻
83 Enhanced
✻
. To clear entries from
✻
56
✻
81
✻
] and [#].
✻
] and [#].