Honeywell WAVE2EX - Ademco Two Tone Siren Installation And Setup Manual page 9

AlarmNet 7845GSM*, 7845i-GSM*, 7845i-ENT or 7845i, Communications Device
The 7845i-ENT/7845i and 7845CV2 can not be used for installations requiring 24-hour standby.

1. Connect the 4-wire communications cable to the LRR/IP Communications port on the LYNXR-I.
2. Connect the four wires to the specific Communications device as shown in the accompanying figures.
3. If you are installing a 7845GSM or 7845i-GSM you must also install a jumper between terminals 2 and 3 on the
communications device.
4. Connect the device to the Internet via a cable/DSL modem and router or to an Intranet (LAN) via the appropriate Ethernet
connection, if applicable.
LYNX
(OPTIONAL)
SUPER HIGH
REQUIRED FOR
CAPACITY
24-HR BACKUP
BATTERY
* When available. The AlarmNet 7845GSM and 7845i-GSM modules have not been evaluated by UL.
LYNX
STANDARD
CAPACITY
BATTERY
4-WIRE CABLE (N4632-4)
LRR/IP COMMUNICATIONS PORT
LYNXR-I CONTROL PANEL
LYNX
STANDARD
CAPACITY
BATTERY
Connecting AlarmNet 7845GSM* / 7845i-GSM*
4-WIRE CABLE (N4632-4)
LRR/IP COMMUNICATIONS PORT
LYNXR-I CONTROL PANEL
Connecting AlarmNet 7845i-ENT/7845i
LYNXR-I Installation and Setup Guide
RED
GRN
RED
BLK
GRN
YEL
- 9 -
TB1
1
2
4 ECP (+) VOLTAGE INPUT
3
BLK
GND
4
YEL
5
5 Z1/Z2 OR DATA IN
6 Z3 OR DATA OUT
7845GSM / 7845i-GSM
7845i-GSM-010-V0
7845i-ENT / 7845i
TB 1
RED BLK GRN YEL
07000-013-V2