Raid Driver Installation For Suse* Linux; Raid Driver Installation For Novell Netware; Installation In A New Novell Netware* System - Intel AFCSASRISER User Manual

RAID Driver Installation for SuSE* Linux

SuSE* Linux uses a program called YaST2 (Yet another System Tool) to configure the
operating system during installation. For complex installations, you can select "Install
Manually" at the first install screen and a different program,
assumes a straightforward installation using YaST2.

RAID Driver Installation for Novell NetWare*

Installation in a New Novell Netware* System

Follow the instructions in the Novell Netware* Installation Guide to install Novell Netware in
the server. Perform the following steps to install Novell NetWare using your Intel
controller as a primary adapter.
Note: Drivers for Novell Netware* are not available on the CD-ROM. The latest drivers are available at
http://www.intel.com/support/motherboards/server/
®
Intel RAID Software User's Guide
1. Insert CD-ROM disk 1 into the CD-ROM drive and the RAID controller driver diskette
in the floppy drive.
1. Boot to the CD-ROM.
2. The operating system loads a minimal operating system from the CD-ROM onto a
RAM disk. The operating system also loads any driver module found in the floppy
drive.
3. At the Welcome to YaST2 screen, select your language and click Accept.
4. At the Installation Settings screen, set up the disk partitioning.
5. Continue with the SuSE* Linux installation procedure.
1. Boot from Novell NetWare*.
2. Follow the instructions on the screen until you reach the Device Driver screen, which is
used to modify drivers.
3. Select Modify and press <Enter>.
4. On the Storage Driver Support screen select Storage Adapters and press <Enter>.
5. Delete any existing Intel
6. Press <Insert> to add unlisted drivers.
7. Press <Insert> again.
A path is displayed.
8. Press <F3>.
9. Insert the driver disk into the floppy drive, and press <Enter>.
The system will locate the .HAM driver.
10. Press the <Tab> key.
11. Select the Driver Summary screen, and press <Enter>.
or from your CDI account.
®
RAID adapter listings.
, is used. This section
linuxrc
®
RAID
37