Stabilizing The Rack; Standalone Racks - HP 245161-B22 - 10642 42U Rack Shock Pallet Reference Manual

Preparing the Rack

Stabilizing the Rack

WARNING: The rack allows you to stack computer components on a vertical
rather than a horizontal plane. To reduce the risk of personal injury or damage
to the equipment, you must follow these instructions carefully and heed all
cautions and warnings throughout the installation instructions.

Standalone Racks

If you are installing a single (standalone) rack, make sure that the rack is level and
that the stabilizing feet have been attached, before installing the components. If an
unstable rack is loaded with components, it can become unbalanced and may tip over.
Extending the Leveling Feet
CAUTION: To reduce the risk damage to the casters, make sure that the full weight
of the rack rests on the leveling feet, and not on the casters. The casters are
designed only as an aid in moving the rack into position. They are not designed to
support the weight of the rack and may become damaged if relied on to support the
rack.
The leveling feet, located beside each caster on the rack, unscrew and extend to the
floor, resting in leveling feet bases provided with your rack. These feet support the
rack and help compensate for uneven surfaces.
After positioning the rack in its final location, use an adjustable wrench to extend the
leveling feet to the base until the weight of the rack is fully on the feet and feet bases,
not the casters. This stabilizes the rack for installation of your components.
3-8 HP 10842 Rack Reference Guide