Table of Contents
Advertisement
3.3.3
Client Detection and Management
Your client is not managed by any ViewSonic Device Manager by factory default. To manage your clients with
ViewSonic Device Manager, you need to first detect unmanaged clients over your local network, and then add them
into a managed group under your ViewSonic Device Manager.
To look for a thin client over your local network, you can use different client detection options available under the
Scan tab.
The following table shows prerequisites and methods for detecting clients over your local network:
Type
Model
SC-T35
Thin Client
SC-T45
NOTE
• If the computer where an ViewSonic Device Manager is installed connects to a local
network, then the ViewSonic Device Manager is connected to the local network.
• After adding clients into a managed group under your ViewSonic Device Manager,
you can start remote management of clients. For detailed instructions on how to
manage your clients remotely, please refer to section "3.4 Managing All Your Clients"
on page 41.
Prerequisites
• clients are connected to the local network
• clients are powered up
35
Using ViewSonic Device Manager
Adding Clients into a Managed Group
Method
Manual
Scan
Section
Page
3.3.4
36
3.3.5
37
3.3.6
38
Advertisement
Table of Contents
