Restoring The System State With A Created Snapshot - ViewSonic SC-T45 User Manual

Sc-t45 user guide m region (english)

Hide thumbs Also See for SC-T45:

Table of Contents

Configuring Client Settings

Configuring System Settings

2. Under the Snapshot section, click the drop-down menu to select where to store the system backup.

Two options are available: Network and USB.

• To store the backup file set on the remote computer, please select Network.

• To store the backup file set on the locally attached USB fresh drive, please select USB.

3. Type in the desired description for this system backup, and then click Apply.

4. A message appears prompting for confirmation. Click OK to confirm.

5. The system will restart to complete the process automatically.

3.2.7 Restoring the System State with a Created Snapshot

System snapshots may be located on two places: a remote computer over the network or a USB flash drive.

NOTE

• For more information on the location of system snapshots, please refer to

section "3.2.6 Taking Snapshots for System Backup and Recovery" on page 23.

Depending on where your system snapshot is located, you can restore the system state either through a

network or a USB flash drive.

With a System Snapshot on a Remote Computer

To restore the system state with a snapshot on a remote computer, please do the following:

1. On ViewSonic Client Setup, click System > Firmware Update.

Table of Contents