Table of Contents
Advertisement
Keep ACS configuration
6. Click Update firmware to confirm your selections. The system will start updating its firmware after
restarting.
3.2.6 Taking Snapshots for System Backup and Recovery
A snapshot is the system backup of a client at a specific point of time, allowing you to restore the client to
that system state. This system backup can be stored on a remote computer or a locally attached USB flash
drive.
NOTE
• To store the system backup on a remote computer, ensure that the client has
been added into a managed group under ViewSonic Device Manager installed
on that remote computer.
To take a system snapshot for a client, please do the following:
1. On ViewSonic Client Setup, click System > Snapshot.
Click to choose whether to keep client settings.
NOTE: If Yes is selected, all client settings will remain unchanged after firmware update. If
No is selected, all client settings will be restored to the factory default, and the client
will become unmanaged.
NOTE: An unmanaged client is the client that is not added into a managed group under
ViewSonic Device Manager installed on a remote computer. For more information
on ViewSonic Device Manager, please refer to the User's Manual for ViewSonic
Device Manager.
23
Configuring Client Settings
Configuring System Settings
Advertisement
Table of Contents
