Table of Contents
Advertisement
Setting Up Your SC-T45
Getting Connected
Step 5: Mount Your SC-T45
To mount your SC-T45 on the back of a monitor, please do the following:
1. Refer to
Step 2
and
• You will need two (2) screws of type
• You will need two (2) screws of type
2. Place your SC-T45 on a flat surface with the VESA mount hole side upward.
3. Refer to
Step 2
to choose two of the four VESA mount holes on the bracket to align with two mount
holes on your SC-T45 such that the bracket projects out and is closer to the rear panel than the front
one as shown below, and then secure the bracket to your SC-T45 with two (2) screws of type
4. Align the mount holes on the bracket with the mount holes on the back of the monitor, and then
secure the bracket to the monitor with two (2) screws of type
located in the center of the monitor and the rear panel of your SC-T45 is facing rightward as shown
below.
2.2 Getting Connected
To make connections for your SC-T45, please do the following:
1. Connect your SC-T45 to your local network with an Ethernet cable.
2. Connect a keyboard and mouse to your SC-T45.
3. Connect and turn on the monitor(s).
4. Connect your SC-T45 to a power outlet using the AC adapter included in the package.
5. Connect other peripherals for your SC-T45 if needed.
Step 4
to prepare required screws for mounting your SC-T45.
2
to secure the bracket to your SC-T45.
1
or
2
to secure the bracket to the monitor.
2
1
or
. Ensure that your SC-T45 is
12
2
.
Have SC-T45's rear
panel
facing rightward.
Advertisement
Table of Contents
