Table of Contents
Advertisement
Setting Access Privileges and Password Also for Standard Users
To set access privileges and password also for standard users, please do the following:
1. On ViewSonic Client Setup, click System > Password.
2. Under the User section, click to check Use Password.
NOTE
• The User section appears only when Active Admin Authentication is
checked.
3. The access privileges for standard users are granted and a window appears for you to set the
password.
4. Type in the desired password, and then click Save to apply.
5. Click Save to store all the changes.
3.2.4 Configuring Shadow Settings for Remote Assistance
The Shadow feature allows an administrator to remotely assist client users in resolving problems or
configuring local settings. When this feature is enabled, an administrator can monitor and control a client
from a remote computer just like a local user.
NOTE
• To use the Shadow feature on a remote computer, you need to install the
ViewSonic Device Manager and also Java software on the remote computer,
and add your client into a managed group under ViewSonic Device Manager.
For detailed instructions, please refer to the User's Manual for ViewSonic
Device Manager.
Configuring Client Settings
19
Configuring System Settings
Advertisement
Table of Contents
