Removing A Cooling Shield For A Hard Drive Installation - Compaq AP500 - Professional - 128 MB RAM Reference Manual

8-4 Drives
Removing a Cooling Shield for a Hard
Drive Installation
A cooling shield covers bays 5 and 6 to provide proper cooling and EMI
protection.
To remove a cooling shield:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the side access panel and front bezel.
3. Refer to the following illustration to remove a cooling shield.
Figure 8-3. Removing a cooling shield
To replace the cooling shield, reinsert the two screws.
IMPORTANT: You will also need to replace the shield after the drive is
installed in the bay.
ACT
CO MP