Standard Features - Compaq AP500 - Professional - 128 MB RAM Reference Manual

1-2 Product Features

Standard Features

The Compaq Professional Workstation AP500 offers the following standard
features. Features may vary depending on your model. For a complete listing
of the hardware and software installed in your workstation run the INSPECT
utility in Chapter 2.
Feature
Processors
Number of Processors
L2 Cache Size
Memory
Optional Memory
Upgrades
Memory Controller
Error Checking and
Correcting (ECC) Memory
Graphics Controller
Expansion Slots
Drive Controller
Table 1-1
Standard Features
Compaq Professional Workstation AP500
Standard with one 400-MHz or 450-MHz Intel Pentium II
processor
One processor, upgradable to two
512 KB
64-MB or 128-MB, 100-MHz Registered SDRAM DIMMs
(upgradable to 1 GB).
Supports 100-MHz ECC 32-MB, 64-MB, 128-MB,
or 256-MB Registered SDRAM DIMMs.
800MB/s single channel memory controller
Uses an encoding scheme for memory error detection and
correction. (Specifically, this feature detects and corrects all
single-bit memory errors, and detects and reports double-bit
errors.)
Ships with 2D/3D or 3D graphics controller. Refer to the
appropriate guide on the SmartStart for Workstations CD
under X:\DOCS\GRAPHICS, where X is your CD-ROM drive
designation.
Six slots with five open. Three dedicated PCI slots. One
shared PCI/ISA slot (1 full-length PCI/ISA). One dedicated
short ISA slot. One Accelerated Graphics Port (AGP) slot
located on system board.
Integrated IDE controller and Integrated Wide-Ultra SCSI
controller on PCI local bus.
Continued