Compaq AP500 - Professional - 128 MB RAM Reference Manual page 30

2-4 Compaq Setup and Diagnostic Software
Computer Setup Features
View information regarding IDE devices
connected to the system
NOTE: ATAPI devices (CD-ROM, tape) are
listed as ATAPI devices.
Set the hard drive to Ultra-DMA (Ultra-ATA),
EDMA, or PIO mode operation
Enable/disable IDE drive translation
Specify the boot order of installed peripheral
devices (such as LS-120 drive, diskette drive,
hard drive, or CD-ROM devices)
Enable/disable serial and parallel port and/or
set resources for onboard system devices
(serial port, parallel port, etc.)
Set the printer mode (flexible/standard)
Set the Num Lock state at power-on
Disable energy save mode
Select timeout values
NOTE: These selections appear only when
energy save mode is set (default).
Enable/disable power LED blink in suspend
mode
NOTE: This selection does not appear if the
energy saver mode is disabled.
Continued
Task Computer Setup Selection
Click Built-in Devices, then click Storage.
The information is displayed under IDE
Devices.
Click Built-in Devices, then click Storage.
Under IDE Devices, select the
appropriate Drive Timing.
Click Built-in Devices, then click Storage.
Under IDE Devices, select IDE Drive
Translation.
Click Built-in Devices, then click Storage.
Click Boot Order.
Click Built-in Devices, then click
Communications. Select the appropriate
options under Serial Ports or Parallel
Port.
Click Built-in Devices, then click
Communications. Under Parallel Port,
select the appropriate Bi-directional Port.
Click Built-in Devices, then click Input
Devices. Under Keyboard, turn on Num
Lock State At Power-on.
Click Built-in Devices, then click Power
Management. Select Energy Save
Disabled.
Click Built-in Devices, then click Power
Management. Under Hard Drive and/or
Monitor, select the Timeout value.
Click Built-in Devices, then click Power
Management. Select Blink LED during
Energy Save.
Continued