Brother Quattro 2 6700D Operation Manual page 31

3
Specifying Stitching Settings
Lines of the drawing are sewn with satin stitches and areas are sewn with fill stitches.
The following settings can be specified.
1 Satin stitch (lines): thickness and stitch density
2 Fill stitch (areas): sewing direction and stitch density
If the drawing data is saved, the settings can be changed after a trial embroidery of the
design is sewn. (Refer to "Saving Image Data" on page 42.)
1. Displaying the Stitching Settings
Screen
1
Press .
2
The screen shown at the left appears.
Reduces the size of the pattern
1
The size of the drawn pattern can be changed. (Refer to
page 34.)
2 Specifies the width of the satin stitches used to sew the
lines of the drawing (Refer to page 32.)
1
Specifies the sewing direction for fill stitches (Refer to
3
page 32.)
2
Specifies the stitch density (Refer to page 33.)
4
3
Corrects shrinkage
4 5
When sewing embroidery, stitched areas may shrink. If
5
this happens, the stitching can be corrected to prevent
shrinkage. (Refer to page 47.)
* To quit specifying settings, press
Notes
• You can use the pen tablet for operations in the stitching settings
screen while moving tablet pen without touching tablet until you are
ready to make selection.
.
31